При сварке заглушек вентиляционного

При сварке заглушек вентиляционного, дренажного отверстий, заглушек патрубка на внутренней и внешней крышках смещение кромок (несовпадение поверхностей соединяемых деталей) со стороны выполнения сварки не должно превышать 0.8 мм (ПНАЭГ 7-010, табл. 9), с обеспечением минимальных размеров разделки кромок (WPS МЦК-02, WPS МЦК-03, WPSМЦК-06).

Результаты (английский) 1:

When welding vent plugs, drain holes stub pipe at the inner and outer covers offset edges (mismatch surfaces of the parts) from the welding should not exceed 0.8 mm (7-010 PNAEG, Tab. 9), ensuring minimal dimensions of cutting edges ( WPS MZ-02, MZ-03 WPS, WPSMTSK-06).

Результаты (английский) 2:

When welding the stubs of the vent, drainage holes, plugs the pipe on the inner and outer lids, the displacement of the edges (mismatch of the surfaces of the connected parts) from the welding line should not exceed 0.8 mm (PNAEG 7-010, table 9), with a tab. 9), with a table. 9), with a number of the surfaces of the connected parts. minimum cuts (WPS ICC-02, WPS ICC-03, WPSMC-06).

Результаты (английский) 3:

When the vent and drain cover are welded, The displacement edge of casing cover on inner cover and outer cover) (the surface of connecting piece does not meet) and welding shall not be more than 0.8mm) (c) To design and construct an alternative, conforming to international standards, conforming to international standards, conforming to international standards, conforming to international standards, conforming to international standards, conforming to international standards, conforming to international standards, conforming to international standards and conforming to international standards.