Счётчик команд работает со сверхопе

Счётчик команд работает со сверхоперативной памятью, которая находится внутри процессора. Эта память носит название очередь команд, куда помещается одна или несколько команд непосредственно перед их выполнением. То есть в счётчике команд хранится адрес команды в очереди команд, а не адрес оперативной памяти.

Цикл выполнения команды – это последовательность действий, которая совершается процессором при выполнении одной машинной команды. При выполнении каждой машинной команды процессор должен выполнить как минимум три действия: выборку, декодирование и выполнение. Если в команде используется операнд, расположенный в оперативной памяти, то процессору придётся выполнить ещё две операции: выборку операнда из памяти и запись результата в память. Ниже описаны эти пять операций.

Результаты (английский) 1:

The program counter is working with cache memory, which is located inside the processor. This memory is called the command queue, where one or more commands directly before they are executed. That is in the meter address is stored command command in the command queue, rather than RAM.Command execution cycle is a sequence of actions, which is committed to run a single processor machine command. When you run each machine command processor must perform at least three steps: fetching, decoding and execution. If a command operand is used in RAM, the CPU will have to perform two operations: fetch the operands from memory and record the result in memory. The following describes these five operations.

Результаты (английский) 2:

Counter command works with cache memory, which is located within the processor. This memory is called the command queue, which is placed one or more teams just before their execution. That is, the counter instruction is stored in the address of the instruction queue, not the address of RAM. The cycle of the command - a sequence of activities that occur in the performance of a single processor machine instruction. At each machine instruction processor must perform at least three steps: fetch, decode and execution. If the team is used operand located in memory, the processor will have to perform two more steps: selection of the operand from the memory and store in the memory. The following describes these five operations.

Результаты (английский) 3:

the teams work with сверхоперативной memory which is inside the processor. this memory is called a turn commands, where the one or more commands are placed directly in front of their implementation.a meter of commands stored in the command queue commands and do not address the ram.

the command execution cycle is a sequence of actions.a processor which is in the performance of one machine commands. in the performance of each machine command processor must perform at least three actions: fetching, decoding and execution.if a team uses the operand located in memory, the processor must perform two operations: the sample операнда from memory and recording the result in memory. following are the five operations.