Собственно нас интересует комплекта

Собственно нас интересует комплектация GUK FA 36-4-SAF с датчиком двойного вложения и счетчиком - необходимо понимание стоимости и сроков поставки.

По возможности, дополнительно интересует вариант поставки клеевой системы hhs (во вложении Клеевая система.rar - контроллер С220 или С221 с двумя головами VD500 (используем холодный клей Eukalin 6271 VL), датчиками, банкой, инкодером и т.д.) – так же необходимо понимание стоимости и сроков поставки. Установку на GUK можем провести своими силами, в зависимости от стоимости установки и сроков. Помимо клеевой системы дополнительно необходимы сегментированные валы 2шт. (фото во вложении Сегм.валы (обведены).jpg), вал фальцовки нижний (во вложении Нижний не сегм.вал ГУК.pdf) и плата управления пультом двойного вложения DBK36(Type: 938-580).

Результаты (английский) 1:

Actually we are interested in bundling GUK FA 36-4-SAF dual sensor attachment and counter-you must understand the cost and delivery time. Where possible, further interested in the hhs system adhesive delivery option (Bonding система.rar attachment controller C220 or S221 with two heads VD500 (use cold glue Eukalin 6271 VL), sensors, inkoderom, etc.)-just need to understand the cost and delivery time. Installation on GUK can hold their own, depending on the installation cost and timing. In addition to adhesive systems needed further segmented shafts 2pcs. (photo pilot valve attachment trees (inside) .jpg), folding shaft lower (Lower pilot valve not attachment. ГУК.pdf shaft) and remote management card dual attachment DBK36 (Type: 938-580).

Результаты (английский) 2:

Actually we are interested in equipment GUK FA 36-4-SAF with dual sensor attachments, and the counter - you need to understand the cost and delivery time.

Where possible, further interested in the option of delivery hhs glue system (see the attachment adhesive sistema.rar - Controller C220 or S221 with two heads VD500 (using cold glue Eukalin the VL 6271), sensors, banks, encoder, etc.) - just as you need understanding the cost and delivery time. Installation on GUK can hold their own, depending on the installation cost and timing. In addition to the adhesive system is further needed segmented shafts 2 pcs. (photo in the attachment Segm.valy (circled) .jpg), folding the lower shaft (not as an attachment Lower segm.val GUK.pdf) and the remote control board double investments DBK36 (Type: 938-580).