Ризван,1. Мы установили Repeaters д

Ризван,
1. Мы установили Repeaters для передачи усиления сигнала на gateway, но мы не можем увидеть на Repeaters сколько детекторов он обслуживает, и не можем сказать именно какой детектор он видит а какой не видит.
2. От 1 до 28 установлены Depol антенны, от 28 - 46 Yagiа антенны.
3. Каждый gateway видят около 35 - 39 детекторов, но на дисплее контроллера намного меньше (фото в приложении), и результат постоянно меняется.

Может ли повлиять детекторы Detcon стоящие по соседству на передачу сигналы детекторов Pemtech?

Результаты (английский) 1:

Rizwan,1. We set the Repeaters to transfer signal amplification at gateway, but we can't see on how many Repeaters detectors it serves and can not say precisely what he sees and what is the detector does not see.2. From 1 to 28 installed Depol antennas, from 28-46 Yagia antennas.3. Each gateway see about 35-39 detectors, but the display controller is much smaller (photo attached), and the result is always changing.Can influence the detectors facing Detcon next door on the transfer of signals Pemtech detectors?

Результаты (английский) 2:

Rizvan,
1. We have established Repeaters for transmitting signal gain at the gateway, but we can not see on many of detectors Repeaters it serves, and we can not say exactly how he sees the detector and which does not see.
2. 1 to 28 are set Depol antenna 28 - 46 Yagia antenna.
3. Each gateway can see about 35 - 39 detectors, but the display controller is much smaller (photo attached), and the result is always changing.

Can affect Detcon detectors standing adjacent to transmit signals Pemtech detectors?

Результаты (английский) 3:

rizvan.1. we have Repeaters for transfer to enhance the signal to the gateway, but we can"t see how he does Repeaters detectors, and we can"t tell exactly what he sees as a detector is not.2. from 1 to 28 are installed Depol antennas, from 28 to 46 Yagiа antenna.3. each gateway can see about 35 - 39 detectors, but the display controller is much less (photo attached), and the result is always changing.can affect the Detcon detectors next to transfer signals of detectors Pemtech?