Зажатие резца производится винтом (

Зажатие резца производится винтом (4), который затягивает клин в паз суппорта и закрепляет резец. Выставляемое по-ложение резца при начальном положении кулачка должно быть не более 1,0 мм от поверхности суппорта. За полный оборот кулачка резец поднимается на 3 мм.

Результаты (английский) 1:

The cutter is jammed screw (4), which draws a wedge into the Groove of the slide and fixes a cutter. Exhibited on the Cutter's proposal at the initial position of the cam should be less than 1.0 mm from the surface of the caliper. For a full rotation of the cam cutter rises to 3 mm.

Результаты (английский) 2:

Clamping tool made screw (4), which draws a wedge into the groove cutter support and fixes. Exhibiting the position of the tool at the initial position of the cam should be no more than 1.0 mm from the surface of a support. For a complete revolution of the cam cutter rises to 3 mm.

Результаты (английский) 3:

Pinched incisor teeth is done by means of screw (4), which sustains a wedge in the slot caliper and enshrines cutter. Risen scandal there, upsetting incisor teeth in the initial position cam should be not more than 1.0 mm from the surface support.For a full turn cam cutter is raised to 3 mm).