При волочении проволоки диаметр отв

При волочении проволоки диаметр отверстия волочильной доски каждый раз уменьшается.
Штамповка листового металла включает в себя ковку, изгиб и обрезку.
Небольшая деформация листа при растяжении помогает сохранить новую форму детали.
Изменение формы при штамповке производится путем сжатия между двумя штампами.
Края листа при штамповке отрезаются для получения конечных размеров.
При проковке деталь должна быть горячей для уменьшения необходимых усилий и увеличения пластичности металла.
После ковки в закрытых штампах детали не требуют большой механической обработки.
При чеканке деформация металла невелика и отпечаток формируется на поверхности металла.
Высадка используется для изготовления головок гвоздей и болтов.

Результаты (английский) 1:

When wire lug hole diameter drawing boards every time decreases.Sheet metal stampings includes forging, bending and shearing.Small deformation of tensile sheet helps to save the new shape of the part.Change form when stamping is made by compressing between the two stamps.Sheet edges at stamping die is cut to obtain the final dimensions.When prokovke detail must be hot to reduce effort required and increase the plasticity of metal.After forging in closed dies do not require large parts machining.When coinage metal deformation is small and the imprint is formed on the surface of the metal.Landing is used for making heads of nails and bolts.

Результаты (английский) 2:

When wire drawing hole diameter of the drawing board each time is reduced.
Sheet Metal Stamping includes forging, bending and cutting.
Small deformation of the sheet in tension helps to keep the new shape of the part.
The change in shape during forming is performed by compressing between two dies.
The edges of the sheet during punching cut off to obtain the final dimensions.
When forging detail must be hot to reduce the effort required and increase the plasticity of the metal.
After forging, closed-die parts do not require much machining.
With the minting of metal deformation is small and the imprint is formed on the metal surface.
The landing is used for making nails heads and bolts.

Результаты (английский) 3:

in волочении wire diameter holes rolling board every time is reduced.stamping sheet metal includes forging, bend and the crop.a small deformation of sheet resistance helps retain the new shape details.change in form with that produced by the compression between the two stamps.the edges of the sheets in that отрезаются to obtain final size.in проковке detail must be heated to reduce the effort and increase the plasticity of metal.after forging in closed with the details do not require great mechanical processing.in чеканке deformation of metal is small and the print is formed on the metal surface.the used for the manufacture of nails and screws.