Кто изобрёл асинхронный двигатель?–

Кто изобрёл асинхронный двигатель?
– Насколько я помню, профессор из Турина Феррари и американский инженер Тесла сделали это. На сначала это техническое достижение мало признавали.
– Но это было очень важным достижением! Принцип работы асинхронного двигателя не изменился с тех пор, хотя он был значительно усовершенствован, и его мощность возросла во много раз. Как он устроен?
– Он известен как “беличье колесо”. Два медных или алюминиевых жёстких кольца соединены параллельными стержнями. Это сооружение встроено в медный цилиндр, находящийся на валу, который представляет собой ротор, вращающуюся часть. Неподвижная часть, статор, состоит из множества соединённых между собой электрических проводников, называемых обмоткой.
– Понятно. Но, недостатком этого двигателя была его неизменная скорость. И только в 1959 году исследователям из Бристольского университета удалось построить двигатель с двумя скоростями.

Результаты (английский) 1:

Who invented the induction motor?-As far as I remember, Professor from Turin Ferrari and an American engineer Tesla did it. At first it is a little technical achievement recognized.-But it was a very important achievement! Working principle of asynchronous motor has not changed since then, although it has been greatly improved, and his power has increased many times over. How it works?-It is known as the "hamster wheel". Two copper or aluminum rigid ring connected parallel rods. This construction is built into the copper bulb located on the shaft, which is a rotor, rotating part. Fixed part stator consists of many interconnected electrical conductors, called winding.-Clear. But the downside of this engine has been his constant speed. And only in 1959 year researchers from Bristol University has managed to build a motor with two speeds.

Результаты (английский) 2:

Who invented the induction motor?
- As I recall, a professor from Turin Ferrari and American engineer Tesla did it. At first it is a little recognized technical achievement.
- But it was a very important achievement! The principle of the induction motor has not changed since then, although it has been greatly improved, and its capacity has increased many times over. How it works?
- It is known as "squirrel-cage". Two copper or aluminum rigid rings are connected parallel rods. This structure is embedded in a copper cylinder, located on a shaft which is a rotor rotating part. The fixed part, the stator consists of a plurality of interconnected electrical conductors, called windings.
- Of course. However, the disadvantage of this engine has been its constant speed. It was only in 1959, researchers from the University of Bristol have managed to build a two-speed motor.